How To Install Vanity Countertop

How to tile a bathroom vanity countertop

October 1, 2022 at 8:14am AM EDT

Yous can change the entire look of your bathroom with a tiled vanity summit– information technology's a project you lot can practice yourself with a moderate amount of skill, a footling patience and a weekend of work. With so many tile choices of color, pattern and texture, the hardest role could be deciding which tiles to select!

Remove the old vanity top and sink

Step ane is to remove the old vanity elevation and sink. Information technology's critical to accept the vanity level, and then check it with a 4 foot level and shim underneath if necessary. Measure the top for your plywood. The top can be even to the edge or have a one inch overhang on the front and sides. If you're reusing the old sink, trace information technology on the plywood to decide the opening cut dimensions. A new sink should have a template to use for the trace. Using a drill to kickoff the cut, make an opening large enough to insert the jigsaw and cut the sink opening. Dry-fit the sink to check your cuts.

Prep work

Place a water-resistant barrier over the plywood and backerboard. Backerboard can exist cutting with a utility knife and should fit flush confronting the wall. Screw in place with cement screws. Keep checking your levels to be sure everything is squared. Place some wide painter's tape from ½ inch above the countertop upwards the wall to protect against smudges of thin set or grout.

Find out how to lay tile >>

Become to piece of work

Mix thin set according to directions. You'll tile from a front corner and work back. V-cap tiles are the starting edge and cover the front and sides of the wood. Place your tiles with spacers between the v-caps – 1/eight inch is expert for small counters. Push tiles down gently beingness certain you have the backs covered with thin gear up. In the back row and at the rounded edges by the sink the tiles will have to be cut to fit using a wet saw. Turn the tiles upside down and trace the openings to brand your cuts precise. You can use duct tape to hold the outside and backsplash tiles in identify until the thin gear up hardens. Allow tile to dry for 24 to 48 hours.

Don't forget the grout

At present pull out your spacers and mix the grout. Unsanded grout is best for wet areas. Yous can even choose colored grout to compliment the tiles. Place a small pile of grout on the tiles and push the grout between the joints. A tile float tool makes this simple. Fill up all the openings. Using clean water and a sponge, go over the entire countertop to remove excess grout. You might as well use a soft brush and wipe downward again with make clean water. In near an hour you'll be ready to apply tile and grout sealer, bachelor in castor-on liquid or spray formula. Use 3 coats, allowing for drying in between.

Find the different types of counter tops >>

Install the sink

Lastly, install the sink, running a bead of calk down where the rim of the sink will sit to prevent water from traveling down a grout line into your vanity.